Drawing From A Barrel; General Cleaning - NORSE PROFESSIONAL SK135 Manuel D'utilisation

Electric pressure washer

Table des Matières

Les langues disponibles

English

SK135

Drawing from a barrel

First ensure the machine is switched off before connecting / disconnecting any hoses or attachments.

Instead of attaching the hose from pump to tap, use the supplied hose and filter set placing the filter end

in the water supply.

It is advised that the water supply is on the same level as the washer. If you struggle to get initial suction,

remove the outlet hose from the pump and try drawing again - this reduces the pressure on the pump

making it easier to draw. Once flowing, turn engine off and reconnect outlet hose before re-starting.

Distance from Cleaning Surface

Another factor that determines the impact force of the water is the distance from the spray nozzle to the

cleaning surface

Angle to the Cleaning Surface

When spraying water against a surface, maximum impact is generated when the water strikes the

surface head on. However, this type of impact tends to cause dirt particles to embed in the surface,

thereby preventing the desired cleaning action.

The optimum angle for spraying water against a surface is 45 degrees.

Avoid Damaging Surfaces

Damage to surfaces occurs because the impact force of the water exceeds the durability of the surface.

Never use a narrow high impact stream or a turbo / rotary nozzle on a surface that is susceptible to

damage.

The surest way to avoid damaging surfaces:

1. Place the nozzle approximately 4-5 feet from and 45 degrees to the cleaning surface.

2. Vary the spray pattern, spray angle and the distance to the cleaning surface until optimum cleaning

efficiency is achieved without damaging the surface.

Table des Matières

Table des Matières