miniland warmyplus digy Mode D'emploi page 20

ENGLISH
When your milk is defrosted, choose one of the warming settings. Consider the start
temperature of your milk/baby food around room temperature for the warming timings
as rough guideline.
5.3. STERILISATION FUNCTION
In order to perform the sterilisation function, follow the following instructions:
1. Place the device on a suitably flat surface, making sure that it is out of the reach of
children.
2. Insert the plug into the electrical socket. A beeping will be heard and the LED power
status indicator (14) will illuminate with a green colour.
3. Add 50 ml of water to the heating chamber.
4. Place the base for sterilisation (6) at the bottom of the tank and then place the baby
bottle face down on top with any other parts, such as the nipples. DO NOT USE THE
HEATING BASKET (5) SINCE THE HOOD COULD NOT FIT OVER IT.
IMPORTANT: Always use the base for sterilisation. The baby bottle must never
come into direct contact with the heater since this could cause damage.
5. Place the hood (7) over the main body of the device.
6. Push the power button (13)
appear flashing on the display (10).
7. Subsequently, using the selection arrows (11 and 12), increase or decrease
the sterilisation time. Less than eight minutes and more than ten minutes is not
recommended.
8. Push the power button
which indicates the sterilisation cycle in progress (15) will illuminate with a green
colour, and the device will commence operation.
NOTE 1: The steam which is released during the sterilisation process is very hot.
The device must not be touched whilst it is being used.
NOTE 2: If you wish to temporarily interrupt the sterilisation process, push the power
button (13). To restart the process, push the same button again.
If, however, you wish to terminate the sterilisation process completely before the time
indicated runs out, keep the power button
9. Once the sterilisation process has been completed, the device will beep and the
process status indicator (15) will turn itself off to notify the user.
10. Given the high temperatures which could be reached, remove the sterilised parts
very carefully to avoid burns.
NOTE 3: Allow the steriliser to cool down for at least 20 minutes before sterilising again.
to turn the unit on. The pre-set time on the device will
(13) again to start the process. Following this, the LED
(13) pushed down for four seconds.
20