Manual Defrost - miniland warmyplus digy Mode D'emploi

210ml
240ml
270ml
IMPORTANT: By following the instructions of the tables, the temperature should
vary between 70°C and 80°C after heating. However if you find that your bottles
are not warm enough at the end of the heating cycle, use a little more water next
time. If, on the other hand they are too hot, you should reduce the amount of
water used.
FOR THE SAKE OF THE SAFETY OF YOUR CHILDREN - ALWAYS CHECK THE
TEMPERATURE OF THE BABY FOOD/MILK BY PLACING A SMALL AMOUNT ON
A SENSITIVE PART OF YOUR BODY (FOREARM OF THE BACK OF YOUR HAND).
WARNING! Baby bottles and food jars will be hot; remove them with care.
Advices:
· For bottle: tighten the ring and shake well to mix up the contents. Pour a few drops of
liquid on the back of your hand to check the temperature before feeding.
· For baby food jar: When heating jars of baby food, stir the baby food with a spoon
for 15-20 seconds after completion so that the temperature is evenly distributed
throughout the content.
· Use plastic bottles approved for boiling or glass thermo-resistant bottles/
containers with this appliance.
NOTE: If there is not enough water in the receptacle for the time set during the heating
process, the device will beep intermittently at the same time as flashing the digits
representing the remaining time.

5.2. MANUAL DEFROST

1. Place the device on a suitably flat surface, making sure that it is out of the reach of
children.
2. Insert the plug into the electrical socket. A beeping will be heard and the LED power
status indicator (11) will illuminate with a green colour.
3. Fill the bottle warmer with drinking water up to the level of the milk/baby food in
the bottle/container. In case of large amounts of milk/baby food, the maximum level
of water is approximately 1 cm below the top of the bottle warmer.4. Next, using the
selecting arrows, adjust the heating time so that the water introduced into the appliance
boils. Once the water is hot, turn off the appliance by pressing and holding the power
button (10) for 4 seconds.
5. Insert the receptacle to be heated into the body of the device contained by the basket (5).
At this setting, your frozen milk can be defrosted till liquid state. Check the warming
reference table for the expected defrost timings.
6. If after cooling of the water in the appliance, the bottle is still frozen, please repeat
the previously numbered steps.
20ºC
4ºC
20ºC
4ºC
20ºC
4ºC
19
40ml
45ml
40ml
45ml
45ml
50ml
ENGLISH
8'
9'
8'
9
9'
10'