Table Des Matières - Hitachi SYSTEM MMI PACK Manuel D'installation

Room Unit Installation Guide
2
Room Unit Installation Guide
Description
The Room Unit communicates with the RF Receiver on
an 868MHz Radio Frequency (RF) band to control the Heat
Pump System Controller. Neither product will communicate
with other RF products that use different frequencies or
communication protocols.
Note: The RF link between the Room Unit and RF Receiver
in system packs is pre-configured at the factory and
therefore SHOULD be installed at the same site. This makes
the installation process fast and easy, but if products from
individual system packs are separated, or mixed with other
pre-configured system packs during installations please
refer to section 4. Binding / Rebinding Procedure to bind
the desired units together and allow them to communicate
with each other.
Table of Contents
Section
1. Installation Information .........................................................................................................................3
2. Installing the System MMI Pack ............................................................................................................4
2.1 Installing the RF Receiver ..................................................................................................................4
2.2 Installing the Room Unit .....................................................................................................................5
2.2.1 Power Up ....................................................................................................................................5
2.2.2 RF Communication Check ..........................................................................................................5
2.2.3 Locating the Room Unit ..............................................................................................................6
2.3 Communication Loss .........................................................................................................................6
3. Installer Mode .........................................................................................................................................7
3.1 Entering Installer Mode ......................................................................................................................7
3.2 Fail-Safe Mode Setup ........................................................................................................................7
3.3 Using the Room Unit for Specific Applications ..................................................................................8
3.4 Using the Special Features of the Room Unit ....................................................................................8
3.5 Installer Parameters Table .................................................................................................................9
3.5.1 Category 1 - Room Unit Settings ................................................................................................9
3.5.2 Category 2 - System Settings ...................................................................................................10
4. Binding / Rebinding Procedure .......................................................................................................... 11
5. Trouble Shooting .................................................................................................................................12
5.1 Trouble Shooting Guide ...................................................................................................................12
5.2 Diagnostic Mode ..............................................................................................................................12
50036443-002 B - Hitachi Room Unit Inst (EN, F).indd 2
Page
16/09/2008 10:06:28