Dell RapidPower Power Guide D'installation page 19

Attaching the Inlet Power Cord and Support Bracket for 10-A and 12-A Power Strips and 16-A PDUs
1 Attach the inlet power cord to the PDU.
2 Insert the ends of the bracket into the two holes on either side of the inlet connector, and rotate
the bracket until it makes firm contact with the power cord (see Figure 1-8).
NOTE:
For optimum cord retention, apply equal pressure to both sides of the power-cord support bracket until it
closes firmly around the power cord.
Figure 1-8. Attaching the Power Cord Support Bracket
NOTE:
Dell recommends that you label your PDU models and power strips with the corresponding voltages.
Locate the packet of voltage labels (if included in your rack kit contents) and select the corresponding label to affix
to the appropriate model. See Figure 1-2 for kit contents and Figure 1-8 for recommended label orientation.
17
Installation Guide