Dell RapidPower Power Guide D'installation page 14

3 Position the PDU so that the mounting hooks enter the square holes on the vertical or horizontal rail.
4 Push down on the PDU until the mounting hooks seat in the square holes and the release button pops
out and clicks (see Figure 1-4).
Figure 1-4. PDU Installation (0-U Vertical Position)
Installin
g PDUs in the 1-U Mounting Position
The recommended 1-U mounting position for a PDU is at the back of the rack as close as possible to the
installed equipment that it will power. The installation brackets can be attached to the sides of the PDU for
either a back-facing or front-facing orientation. Whichever orientation you use, be sure the PDU placement
allows enough cable slack so that each rack-installed system connected to it can slide freely for servicing.
12
Installation Guide
outlet connector rail cutout
release button