Preparing The Twin Tt For Dry-Vacuuming; Set Up The Aquafilter - Rotho TWINtt Mode D'emploi

Preparing the TWIN TT for Dry-Vacuuming

Before you begin vacuuming, you must prepare the TWIN TT by setting up the AQUAFILTER and at-
taching the dry suction hose.

Set Up the AQUAFILTER

To prepare the AQUAFILTER for dry-vacuuming, do the following:
1. Lift the cover lock.
2. Open the casing cover.
3. Take hold of the small handle at the center of
the AQUAFILTER and remove the AQUAFIL-
TER from the Recovery Tank.
4. Fill the recovery tank with approximately 1
quart of clean water. Use the waterline label
on the inside of the recovery tank to help
you.
Note: A metal handle is attached to the re-
covery tank and folds down to one side. If
desired, you can use this handle to remove
the recovery tank from the vacuum and carry
it to a faucet.
5. Return the AQUAFILTER to the recovery
tank. Make sure that the seal along the top
edge of the AQUAFILTER fits snugly into the
recovery tank.
6. Make sure the wet filter and HEPA filter are
firmly in place.
7. Close the casing cover. Check the casing
cover handle to make sure the cover is fully closed.
The AQUAFILTER is ready for dry-vacuuming.
14
All manuals and user guides at all-guides.com
6
ROBERT THOMAS, L.P. ©2010
3 4
1
2
1qt
5 7