Before First Time Use - OK. OHO 162 M Mode D'emploi

BEFORE FIRST TIME USE

• Remove the product and accessories carefully from the original packaging. It is recommended to keep
the original packaging for storage. If you wish to dispose of the original packaging, please observe
applicable legal provisions. Should you have any questions regarding proper disposal, contact your
local waste management center.
• Inspect the delivery contents for completeness and damages. Should the delivery contents be
incomplete or damaged, contact your sales outlet immediately.
• After unpacking, please refer to chapter Cleaning and care.
OPERATION
Warning: Failure to install the screws or fixing device in accordance with these instructions may result in
electrical hazards
The extractor hood must be fitted at a minimum distance of 65 cm above the cooking surface.
1
The extractor hood can be screwed on at the back or on the top.
Note: If the extractor hood is used in extraction mode, one of the covers for the air canals must be
removed using a suitable tool (levered out).
Remove the protective foil before mounting.
2a If extraction is upwards, remove the cover from the vent hole for vertical extraction. Then insert the
flange provided into the opening.
2b If extraction is towards the back, remove the cover from the vent hole for horizontal extraction.
Then insert the right-angled flange provided into the opening.
Mounting from the back
3 Drill holes of Ø 8 mm into the wall on which the extractor hood is to be mounted.
Use that expansion plugs provided.
One person should hold the extractor hood during fitting while the other person screws the
extractor hood in place.
Screw the extractor hood in place using 2 of the screws provided.
Mounting from the top
4 Please observe the installation dimensions. Drill 4 holes of Ø 6 mm into the underside of the
hanging unit. Attach the air vent to the extractor hood and secure this to the underside of the
hanging unit with the provided screws (x4), nut (x4) and shim (x8).
Adjust steam extraction
5 Press the bars on both sides inwards and fold the air inlet down.
The adjustment flaps are on the left next to the light.
6
If the extractor hood is operated using a vent, push the flap upwards. If no vent is available, the
7
extractor hood can be operated in convection mode. Pull the flap downwards.
IM_OHO162M_170120_V03_HR.indb 10
10
20/1/17 11:58 AM