Carat DPZ01000DD Manuel D'instructions page 16

STEP 2: MOUNTING THE CORRECT CONNECTOR
Upper flange
blade
[i]
[k, m, n, o]
[b, c, d, e, f]
As M14
[h]
[a]
[b, c, d, e, f]
[g]
Thumb screw
16
- Choose the correct connector and fit
it to the main unit [a] using the
wrench [g]
- Hold the main unit and tighten the 2
screws of the connector.
- Release Thumb Screw and open [a]
Main Unit.
- Set the proper Spacer [k, m, n, o]
into the Spindle.
- Set [i] Base Flange on the Spacer
- Set the Blade on [i] Base Flange
- Set the Wheel Nut on the Blade
- Tighten the Wheel Nut
- Confirm NO contact between the
Blade and inner area of [a] Main Unit