Unpacking The Appliance; Starting-Up The Appliance; Using The Appliance - Clatronic WA 3772 Mode D'emploi

• Keep the appliance and its cord out of reach of children less than
8 years.

Unpacking the Appliance

1. Remove the appliance from its packaging.
2. Remove all packaging materials such as films, filler
material, cable clips and carton.
3. To prevent hazards, check the appliance for any
transport damage. Do not put a damaged appliance into
operation. Return it to the dealer immediately.

Starting-Up the Appliance

Electrical Connection
Check whether the mains voltage that you want to use
matches the one of the appliance. You will find the informa-
tion about this on the type plate.
Non-Stick Coating
Before you prepare the first waffles for consumption:
1. Clean the housing and the baking surfaces with a damp
cloth.
2. Lightly grease the baking surfaces before the appliance
is used for the first time.
3. Use the appliance for about 10 minutes with the toasting
surfaces closed (see "Using the Appliance").
NOTE:
• Any smoke or smells produced during this proce-
dure are normal. Please ensure sufficient ventilation.
• Do not eat the waffles prepared during first time
operation.
4. Remove the mains plug from the socket and allow the
appliance to cool down.
5. After the appliance has cooled down, wipe the baking
surfaces off with a paper towel.

Using the Appliance

CAUTION:
Do not use pointed or sharp objects to avoid damaging
the coating of the baking surfaces.
NOTE:
• Keep the baking surfaces closed while heating.
• After heating up the appliance, the green control lamp
will turn off.
• The red control lamp remains on to show that the
appliance is working.
• The green control lamp switches on and off during
baking in order to maintain the baking temperature.
• The baking section should always be closed in the
intervals between baking.
30
WA3772_IM
NOTE:
• Make sure the power cord does not become twisted
with the repeated turning of the appliance. For this
reason, always turn the appliance once to the right and
once to the left.
1. Set up the appliance so that you can see both indicator
lights.
2. Connect the appliance to a properly installed earthed
socket. Both indicator lights are lit. The appliance will
begin heating up immediately.
3. Once the appliance has heated up, open the baking
surfaces using the handle.
4. For best results, use a pastry brush to spread some
shortening on both baking surfaces. Alternatively, spray
the baking surface lightly with edible cooking oil. This
will make it easier to remove the waffles once they have
finished baking.
5. Add some dough to the middle of the lower baking surface.
Spread the dough using a silicone spoon, for example.
NOTE:
• The recesses in the baking surface should be filled,
but the outer edge should remain clear.
• The dough should be filled in quickly as otherwise
the wafers will not brown evenly.
6. Close the appliance. In order to spread the dough
evenly, we recommend immediately turning the appli-
ance around 180 ° degrees. Grasp the appliance by the
handle as you do this.
Now, you will only see the green indicator light on the
appliance.
7.
WARNING:
Be careful of the emitted steam. Risk of burns!
NOTE:
• The baking process lasts approx. 3 minutes. This
may vary depending on the consistency of the
mixture.
09.02.21