Klarstein SKYTOWER 360 SMART Mode D'emploi page 34

EN
34
WIFI function
With the appliance switched on, press and hold the wind mode/WIFI button
for five seconds. A beep is heard and the WIFI indicator (10) flashes rapidly for five
seconds. Apps on the network can be configured in standard mode. If no connection
is established within 3 minutes, the WIFI indicator (10) goes out. To reconnect, press
the wind mode/WIFI button
WIFI indicator flashes rapidly for five seconds. Apps on the network can be configured
in standard mode. Press and hold the wind mode/WIFI button
as soon as the WIFI indicator (10) flashes. A beep is heard and the WIFI indicator
(10) flashes slowly for 5 seconds. Apps on the network can now be configured in
compatibility mode.
Notes on using the WIFI function
• If the appliance is turned off within 10 seconds after it is turned on, the WIFI
indicator (10) returns to the status before it was turned off. If the appliance is turned
off after 10 seconds, the WIFI indicator (10) turns off and enters power-saving
mode. Press and hold the setting button for 5 seconds to restart.
• If the network is not configured within three minutes, the WIFI indicator (10) goes
off. Press and hold the setting button for 5 seconds to restart.
• If the router is switched off after the WIFI connection has been successfully
established, the WIFI indicator (10) also goes out. As soon as the router is switched
on again, the connection to the appliance is automatically re-established.
• When using the WIFI function, the WIFI indicator (10) must flash quickly. A
router (must be able to connect to external networks) and a mobile device (e.g.
smartphone) are required to use the Klarstein app. The Klarstein app must be
installed on the mobile end device that is also connected to the WIFI network.
again. A beep is heard, the WIFI module is reset, the
again for 5 seconds