Datamars Unigizer 12000i Mode D'emploi page 8

6000i, 6000i-EU, X6i, X6i-EU, 406i and
12000i, X12i, 412i,
406i-EU energizers only:
If earth monitoring is desired, connect
the Fence earth monitor terminal (black) to a separate earth
rod. For more information, see page 9.
1 Connect the Fence full voltage terminal (red) or the Fence
half voltage terminal (yellow) to the fence.
2 Connect the battery to the solar panel.
3 Connect the energizer to the battery using the battery
leads provided, but replace the battery lead clips with
permanent battery connectors. See page 6.
Operation
Select the appropriate pulse speed and output power level
using the selector switch.
12000i, X12i, 412i, 6000i, 6000i-EU, X6i, X6i-EU, 406i and
406i-EU energizers only:
When the energizer is switched on, for the first few seconds the
LCD display and the indicator lights show the firmware version
and remote control address setting (only required for advanced
troubleshooting and servicing). After this, the energizer
resumes normal operation. In poor light conditions, when the
selector switch position is changed, the LCD display illuminates
for 20 seconds.
6000, 6000-EU, X6, X6-EU, 406 and 406-EU energizers only:
The energizer begins normal operation within 6 seconds of
being switched on.
8
Using the selector switch
Setting Description
Off The energizer is off and is not operating.
When the selector switch is in the Off
position, the energizer will not respond
to commands from a remote control.
Battery Test The battery voltage is displayed by the
indicator lights (all models) and on the
LCD (12000i, X12i, 412i, 6000i,
6000i-EU, X6i, X6i-EU, 406i, 406i-EU
energizers only). When this setting is
used, the energizer operates at slow
speed (2.5 seconds between pulses).
Slow Speed - The energizer operates at slow speed
Day (2.5 seconds between pulses) during the
Fast Speed - day and fast speed (1.5 seconds
Night between pulses) at night. When this
setting is used, the energizer operates at
full power. This setting is for animals
active during the night and is a useful
way of conserving battery power when a
battery is being used to power the
energizer.
Fast Speed - The energizer operates at fast speed
Day (1.5 seconds between pulses) during the
Slow Speed - day and slow speed (2.5 seconds
Night between pulses) at night. When this
setting is used, the energizer operates at
full power. This setting is for animals
active during the day and is a useful way
of conserving battery power when a
battery is being used to power the
energizer.
Low Power The energizer operates at half power
(12000i, and fast speed (1.5 seconds between
X12i, 412i,
pulses).
6000i, X6i,
406i, 6000,
X6 and 406
energizers
only)