General Electric PFDS450 Manuel D'utilisation Et D'installation page 43

INSTALLING THE PEDESTAL (if desired)
CAUTION
these products, and to reduce the risk of personal
injury or damage to the product, TWO PEOPLE ARE
REQUIRED FOR PROPER INSTALLATION.
KIT CONTENTS
4 Support pads
4 Mounting screws
TOOLS YOU WILL NEED
Phillips-head
screwdriver
9/16" Open-end
wrench or adjustable
wrench
Installation Instructions
Drawer divider
7 mm Socket wrench
INSTALLATION PREPARATION
Remove the packaging.
The drawer divider is taped at the top of the shipping
carton. Remove the divider and set aside for final
installation.
Flatten the product carton to use as a pad to lay
the washer or dryer down on its side. Continue using
the carton to protect the finished floor in front of the
installation location.
1 REMOVE THE LEVELING LEGS
Carefully lay the washer or dryer on its side to
A
access the leveling legs on the bottom of the
appliance.
IMPORTANT: Do not lay the washer or dryer on its
back! Do not remove the shipping bolts on the back
side of the washer. The bolts must remain in place
until the washer is returned to an upright position.
Use an open-end wrench to remove the washer
B
or dryer leveling legs.
Back out and remove
all 4 leveling legs
43