General Electric PFDS450 Manuel D'utilisation Et D'installation page 36

REVERSING THE DOOR SWING (if desired)
REVERSE DOOR HANDLE AND CAPS
3
A Lay the chrome cover down on a soft, protected,
flat surface so that the inner part faces upward
(resting on the handle side). Disassemble the
door cap from the chrome cover on the handle
side by removing 2 screws (#8 x 0.625" tapping
screws).
B Disassemble the outer handle from the inner
handle by removing 3 screws (#8 x 0.625" tapping
screws). Disassemble the inner handle from the
chrome cover by removing 4 screws (#8 x 0.625"
tapping screws).
Remove
4 x D screws
(Inner handle)
Installation Instructions
2 x D
Screws
Door cap
3 x D
Screws
(Outer
handle)
Inner
handle
36
REVERSE DOOR HANDLE AND CAPS
3
(CONT.)
C Pop the 2 handle caps out toward you and
reassemble on the opposite side of the chrome
cover, where you removed the outer handle.
Handle caps
D Assemble the inner handle onto the opposite
side of the chrome cover, using 4 screws (#8 x
0.625" tapping screws).
Inner
handle
Replace
4 x D
screws
(Inner
handle)