Before You Start - General Electric PFDS450 Manuel D'utilisation Et D'installation

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

REVERSING THE DOOR SWING (if desired)

BEFORE YOU START

Unplug the dryer from its electrical outlet.
REMOVE THE DOOR ASSEMBLY
1
Remove the side hinge cap by opening the dryer
door and removing the screw from behind the
hinge (#8 x .375" tapping screw). Then using your
hand, pop the hinge cap off the dryer.
1 x C Screw
Installation Instructions
Hinge
cap
35
REMOVE THE DOOR ASSEMBLY (cont.)
1
Close and hold the door, remove the 2 hinge screws
(#10 x 0.75" tapping screws). Pull the door away
from the dryer front panel.
DISASSEMBLE THE DOOR ASSEMBLY
2
Lay the door down on a soft, protected, flat surface
so that the inner part faces upward (door resting on
the handle side).
Remove the 7 screws (#10 x 1.125" tapping screws)
located around the perimeter of the door.
7 x A Screws
Turn the door assembly over and separate the
chrome cover from the inner door. Put the inner
door aside on a soft, protected flat surface.
2 x B
Screws

Publicité

Chapitres

Table des Matières
loading

Produits Connexes pour General Electric PFDS450

Ce manuel est également adapté pour:

Pfds455Pfdn440Pfdn445Pfms450Pfms455Pfmn440 ... Afficher tout

Table des Matières