Stacking The Washer; Installation Preparation - General Electric PFDS450 Manuel D'utilisation Et D'installation

STACKING THE WASHER AND
DRYER (if desired) (cont.)
KIT GE FL STACK CONTENTS
Right hand bracket
Left hand bracket
4 rubber pads
TOOLS YOU WILL NEED
Phillips screwdriver
Open-ended wrench
Pliers

INSTALLATION PREPARATION

Remove the packaging.
Flatten the product carton to use as a pad to
lay the dryer down on its side. Continue using
the carton to protect the finished floor in front of
the installation location.
Installation Instructions
4 #12 x 1" screws
4 #8 x 1/2" screws
Gloves
Level
INSTALLING THE STACK BRACKET
KIT
REMOVE THE DRYER LEVELING LEGS
1
A. Carefully lay the dryer on its side. Use the packing
material so you don't scratch the finish on the
dryer.
B. Use an open-end wrench or pliers to remove the
dryer leveling legs.
Back out and remove
all 4 leveling legs
INSTALL RUBBER PADS TO DRYER
2
BASE
Locate the 4 rubber pads in the parts package.
Remove the adhesive backing and firmly place
over on the bracket where you removed the
leveling legs.
41