Installation Requirements; Clearance Requirements - Kenmore 132901660A Instructions D'installation

Installation Requirements

Electrical system requirements
CIRCUIT - Individual, properly polarized and grounded 15
amp. branch circuit fused with 15 amp. time delay fuse
or circuit breaker.
POWER SUPPLY - 2 wire, with ground, 120 volt single phase,
60 Hz, Alternating Current.
NOTE
Because of potentially inconsistent voltage capabilities,
the use of this washer with power created by gas
powered generators, solar powered generators, wind
powered generators or any other generator other than the
local utility company is not recommended.
OUTLET RECEPTACLE - Properly grounded 3-prong
receptacle to be located so the power supply cord is
accessible when the washer is in an installed position.
Grounding type Grounding type
wall receptacle
Power cord with wer cord with
3-prong grounded plug ounded plug
NOTE
GFI (Ground Fault Interrupter) receptacle is not required.
Ground requirements
WARNING
ELECTRICAL SHOCK HAZARD
Improper connection of the equipment grounding
conductor can result in a risk of electrical shock. Check
with a licensed electrician if you are in doubt as to
whether the appliance is properly grounded.
1 The washer MUST be grounded. In the event of
malfunction or breakdown, grounding will reduce the
risk of electrical shock by a path of least resistance
for electrical current.
2 Since your washer is equipped with a power supply
cord having an equipment-grounding conductor and
a grounding plug, the plug MUST be plugged into an
appropriate, copper wired receptacle that is properly
installed and grounded in accordance with all local
codes and ordinances or in the absence of local codes,
with the National Electrical Codes, ANSI/NFPA 70
(latest edition). If in doubt, call a licensed electrician.
DO NOT cut o or alter the grounding prong on
the power supply cord. In situations where a two-slot
receptacle is present, it is the owner's responsibility to
have a licensed electrician replace it with a properly
grounded three prong grounding type receptacle.
Do not, under Do not, under
any circumstances, cumstances,
cut, remo remove ve,
or bypass th ypass the
grounding pr ounding prong. ong.
Water supply requirements
Hot and cold water faucets MUST be installed within hose
length of your washer's water inlet. The faucets MUST
be 3/4 inch (1.9 cm) with threading for laundry hose
connection. Water pressure MUST be between 10 and 110
psi. Pressure di erence between hot and cold cannot be
more than 10 psi. Your water department can advise you of
your water pressure.
Drain system requirements
1 Drain capable of eliminating 6 gals (22.5 L) per
minute.
2 A standpipe diameter of 1-1/4 in. (3.18 cm) minimum.
3 The standpipe height above the oor should be:
Minimum height: 24 in. (61 cm)
Maximum height: 56.5 in. (144 cm)
56.5"
(144cm)
max.
24"
(61cm)
min.

Clearance requirements

MINIMUM INSTALLATION CLEARANCES - Inches (cm)
SIDES
Alcove 0" (0 cm) 0" (0 cm)* 0" (0 cm)
Under Counter 0" (0 cm) 0" (0 cm)* 0" (0 cm)
0"
(0cm)
4
REAR TOP
0"
(0cm)
0"
(0cm)
FRONT
n/a
n/a