Charging The Appliance; Using The Appliance; Brushing Instructions - Philips Sonicare DailyClean 3100 2 Serie Mode D'emploi

10
English

Charging the appliance

1 Plug the charger into a live electrical outlet.
2 Place the handle on the charger (Fig. 4).
-
The light of the battery level indicator flashes and the appliance
beeps twice. This indicates that the toothbrush is charging (Fig. 5).
Note: It can take up to 48 hours to fully charge the battery, but the
Philips Sonicare may be used before it is fully charged.

Using the appliance

Brushing instructions

1 Wet the bristles and apply a small amount of toothpaste.
2 Place the toothbrush bristles against the teeth at a slight angle
(45 degrees), pressing firmly to make the bristles reach the
gumline or slightly beneath the gumline (Fig. 7).
Note: Keep the center of the brush in contact with the teeth at all
times.
3 Press the power on/off and mode button to turn on the Philips
Sonicare.
4 Gently keep the bristles placed on the teeth and in the gumline.
Brush your teeth with small back and forth motion so the bristles
reach between the teeth. Continue this motion throughout your
brushing cycle.
Note: The bristles should slightly flare. Do not scrub.
5 To clean the inside surfaces of the front teeth, tilt the brush handle
semi-upright and make several vertical overlapping brushing
strokes on each tooth (Fig. 8).
Note: To make sure you brush evenly throughout the mouth,
divide your mouth into 4 sections using the Quadpacer feature
(see chapter 'Features').
35_021_1325_1_DFU_BookletSimp_A6_v1.indd 10 23/12/15 11:28