Using The Appliance - Philips Sonicare AirFloss HX8211/02 Mode D'emploi

Note: To operate effectively, the AirFloss has to contain either mouthwash or water.
Tip: For a fresher experience, use mouthwash instead of water.
Note: Do not use mouthwash that contains isopropyl myristate (e.g. Dentyl
Active) or high concentrations of essentials oils, as it may damage the
appliance. This includes all mouthwash sold in glass and ceramic packaging.
4 Close the cover of the reservoir ('click') (Fig. 7).
5 Press the on/off button (Fig. 8).
The green charge indicator lights up.
,
6 Press and hold the activation button until spray comes out of
the tip of the nozzle (Fig. 9).

Using the appliance

1 Make sure the AirFloss is switched on (Fig. 8).
2 Place the tip between the teeth and apply gentle pressure.
Slightly close your lips over the nozzle when it is in place,
to avoid splashing (Fig. 10).
Tip: Use your finger to press the activation button.
Note: The AirFloss is intended to be used on the front/outside surface of
the teeth only.
3 Press the activation button to deliver a single burst of air and
micro-droplets of mouthwash or water between the teeth.
Alternatively, hold the activation button to deliver continuous
bursts of mouthwash or water approximately every 1 second
(select models) (Fig. 11).
4 Slide the guidance tip along the gum line until you feel it settle
between the next two teeth.
5 Continue this procedure for all spaces including behind your back
teeth (Fig. 12).
6 To switch off the AirFloss, press the on/off button again.
ENGLISH
9