Sonnenstrom Fabrik Excellent Notice De Montage page 16

Warning: Danger due to high voltage!
Even in disconnected condition the inverter can re-
tain high voltages, which is a major shock hazard.
Therefore:
• Be very cautious when working with the
inverter and wires!
• After switching off the inverter as well as
before working on the inverter, make sure
to regulate the time intervals as recom-
mended by the manufa turer so that the
high voltage components can be dischar-
ged!
Make sure to adhere to the assembly regulations
of the inverter manufacturer!
Warning: Danger due to electric arc!
The solar modules generate a direct current
when exposed to light. When opening a closed cir-
cuit, e.g. disconnecting the direct current wire from
the loaded inverter, a fatal electric arc may occur.
• Never disconnect the solar generator from
the inverter while the inverter is connected
to the grid!
• Make sure to use only flawless wire con-
nections! Connect wires seamlessly and
keep them free from dirt!
Electrical Installation
The solar modules are designed for use in PV sy-
tems of application class A and are approved for
operation in systems with dangerous direct cur-
rent (more than 120 V DC in accordance with EN
61730) and power. PV modules of this application
class are approved for operation in installations
with unrestricted access. Sonnenstromfabrik mo-
dules of this class, which are qualified under EN
61730 and have been properly installed, meet the
requirements of protection class II.
16
Transport, temporary
storage and safe unpacking
The modules are sensitive technical components,
which must be handled with utmost care. There-
fore, be particularly careful during transport and
temporary storage and leave the modules in the
package until they are used. Always lift and car-
ry the module with both hands and never carry by
means of the junction box.
Do not drop the modules or place them down
clumsily on a hard floor and/or on the module
co ners. Do not place any objects on the mo-
dules. Do not stack the modules without pro-
tection.
Avoid deflection of the modules. Do not walk
on the modules. Do not treat with sharp objects
and keep all electrical contact areas clean and
dry.
For documentation purposes, the serial number
should be noted. If required, the modules should be
temporarily stored in a dry, ventilated room. Clean,
non-slip gloves must be worn during all transport
and installation work to prevent cut injuries from
the panel edges. Contamination of the solar glass
with fingerprints must also be avoided, as this may
damage the special coating on the glass.
Please pay special attention to the warnings on
the package as well as on the enclosed unpa-
cking instructions!