Assembly; Mounting The Handle - Greencut GM650X Manuel D'utilisation

Masquer les pouces Voir aussi pour GM650X:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Model/
Accessories
GM650X-2
X
GM650X-4
X
GM650X-5
X
GM650X-6
X
GM650X-9
X

ASSEMBLY

CONNECTING THE THROTTLE AND SWITCH
1.
Remove the air filter cover.
2.
Thread the "adjusting nut" counterclockwise (clockwise) away from the end of the cable.
3.
Thread the "lock nut" counterclockwise (clockwise) away from the end of the cable.
4.
Slide the "throttle cable" in and through the "gap".
5.
Connect the end of the "throttle cable" to the "cable fixing accessory".
6.
Screw the "lock nut" clockwise (to the left) onto the clamping plate until it is flush with the "gap".
7.
Using a wrench, tighten the throttle "adjusting nut" until it snaps against the "lock nut" and the "stay".
8.
Connect the accelerator cables. The colors of the wires may or may not match, no matter how they are
connected.

MOUNTING THE HANDLE

Place the anti-vibration rubber and the two parts of the handle at the desired height and secure them with the four
bolts.
X
X
X
X
X
X
X
X
X
X
X
X
X
X
X
X
X
X
X
69
3
1
X
X
3
EN

Publicité

Table des Matières
loading

Table des Matières