Yakima RailGrab 2 Mode D'emploi page 6

Overview
Adjust the claw vertically.
Loosen knob.
Check your work.
Did you establish three
solid contact points?
Note: rounded factory racks may
only require two points of contact.
1033506C-6/27
Install first
Claw Set Up
set of towers
The goal is to move the claw vertically and horizontally to fit with
your factory rail. These adjustments must be made in tandem.
You must establish three solid points of contact.
NOTE: It may be
necessary to alternate
between step 3 and step
4 until a solid connection
is achieved.
Adjust claw
vertically.
Tighten
knob.
CONTACT POINT 1
CONTACT POINT 2
Determine Install second set
crossbar spread of towers
Adjust the claw horizontally.
Turn the black claw tightener, using
the supplied wrench, clockwise to
adjust the distance between the
claw and the factory rail.
With the RailGrab
covers open...
Locate the black
claw tightener.
Horizontal
CONTACT POINT 3