Harrie Leenders TRIAS Instructions D'installation page 26

Maintenance
Maintenance enamelled parts
Dust the Trias using a non-fibrous cloth.
Clean with lean soapsuds if necessary. Rinse
thoroughly and heat the Trias so that moisture
in cracks and slits can evaporate.
Maintenance ceramic firebricks
You need not worry about any cracks in the ceramic firebrick elements as long as the flame does not come into direct
contact with the metal behind them. Should this be the case, however, then it will be necessary to replace the brick;
contact your supplier.
Maintenance glass
The glass is steamed up when burning wet fuel or too little oxygen is supplied. Also, the glass may steam up if the fire does not start fiercely enough.
This happens, for instance, when you start with small logs instead of thin kindling wood. Moisture will then remain in the fireplace for too long, and
will settle on the coldest part: the glass.
Light moisture:
Use paper towel and then remove the light
moisture using a damp cloth.
Counter pressure a little at the outside so that
the windowpanel does not move.
Maintenance moving parts
Moving and squeaking parts can be lubricated using graphite grease. Ask your supplier for advice.
Collecting soot when sweeping the chimney
1. Close the aeration slide and remove the
two heatshields from the fireplace.
26 GB
Damaged spots can be touched up using an
abrasive cloth and the special stove paint.
Ask you supplier for advice.
Thicker deposits:
These can be treated with special fireplace-
glass cleaner (this can also be done with a
piece of moist paper towel and white ash).
Allow a moment for this to have its effect.
Always make sure that these agents do not
come into contact with the enamel in order to
prevent stains from being formed.
2. Place a newspaper on the bottom so that
soot can be easily removed afterwards.