Inside Antenna Installation; Powering Up The Signal Booster - Wilson Electronics WilsonPro A1000 Instructions D'installation

Inside Antenna Installation

1. Select a location in the center of
the area where you want cellular
signals improved to mount the Inside
Antenna. If you have multiple rooms
with poor signal, you may need
multiple Inside Antennas. These
can attach to the Signal Boost by
using a splitter (sold separately).
Contact Wilson Electronics for more
information.
2. Ensure a minimum of 6 vertical
meters or 15 horizontal meters of
separation from the Outside Antenna.
Outside Directional
Antenna
Place the inside antenna
directly beneath the
placement of the Outside
Antenna location
At least 6 of vertical meters
or 50 horizontal meters of
separation
Inside Panel Antenna
6
3.
4.

Powering Up The Signal Booster

1.
2.
3.
Need help?
support-gh@techlineglobal.com
Inside Antennas can be mounted
above ceiling drywall, on a ceiling
inside a room, or on a wall inside a
room. Ensure the Inside Antenna is
facing AWAY from the Outside Antenna
to avoid oscillation (feedback) and
reduced performance.
Face inside
antenna
away from
the outside
Outside antenna.
Antenna
Use the mounting hardware included
in the package to secure the Inside
Antenna to the selected location.
Ensure the cables to both the Outside
Antenna and Inside Antenna are
securely connected before powering
up the Signal Booster.
Plug the power supply into the Signal
Booster input marked "POWER" and
then into a surge protector power strip
with a minimum 1000 Joule rating.
!
The lights on the Signal Booster should
remain green . If the lights are not
green, see the "Troubleshooting" section
starting on page 7.
Inside
Antenna