Installation Details - Wilson Electronics WilsonPro A1000 Instructions D'installation

b. The person on the roof should turn
the Outside Antenna 45 degrees
at a time. Allow 30 seconds for the
phone to register with each turn.
Cell Tower
Outside Directional
Antenna
c. The person inside should note the
readings on the phone with each
turn. Signal readings usually appear
as a negative number. The closer the
number gets to zero, the stronger the
signal (for example, -86 dB would be
a moderately good reading while -55
dB would be an excellent reading,
and -110 dB would be a weak, or
unusable signal).
Cell Tower
Outside Directional
Antenna
d. Once you have determined which
direction provides the strongest
outside signal, you can install the
Outside Antenna in that general
direction.
Good methods:
2.
a. Place calls from several locations
outside your building. As you move
to different locations, note where
you get the best reception.
b. If you have a smart phone, you
can download apps that help you
identify locations of cell phone
towers or the strongest signal. Go
to the App Store and search for
"cell signal" to find available apps
for your device.
3. Acceptable method: Check the bar
indicator on your cell phone display
and note where the signal appears
the strongest. (Note: cell phone
4

Installation Details

As you plan your installation, keep the
following guidelines in mind to maximize
your signal strength:
1.
2.
3.
4.
To install the Lightning Surge Protector,
attach the cable from the Outside Directional
Need help?
support-gh@techlineglobal.com
bars are only an approximation of
signal strength and vary from phone
to phone.) Phones can take up to 30
seconds to reset to a new reading. Be
patient and repeat your signal check
several times.
WAIT 30
SECONDS
Maintain a vertical distance of at least
6m or a horizontal distance of at least
15m between the Outside Antenna to
the Inside Antenna.
If possible, place the Inside Antenna
directly beneath the placement of the
Outside Antenna location. This creates
a maximized signal zone within the
room where the Inside Antenna is
located.
Outside Directional
Antenna
Place the inside antenna
directly beneath the
placement of the Outside
Antenna location
At least 6m of vertical or 15m
of horizontal separation
Inside Panel Antenna
Be sure the Inside Antenna is NOT
facing toward the Outside Antenna.
This creates potential oscillation
or feedback and reduces the
effectiveness of the A1000-3G/4G.
If you do not know how to mount
hardware or run coax cable through
walls, ceilings and floors, get help
from a from a qualified contractor or
electrician.