Inside This Package; Install Overview - Wilson Electronics Pro Serie Guide D'installation

Inside this Package

To purchase Expansion Kits call Wilson Electronics Sales Department at:
Wide Band Directional
Signal
Antenna 75' RG11 Cable
Booster
(314475-1175)

Install Overview

Refer to Installation Diagram on page 3 & 4. Contact Wilson Electronics Technical
Support Team with any questions at 866-839-9361
1. Select a location on the roof or outside of the building to install the outside
antenna. Refer to pages 3 & 5.
2. Select a location to install the Signal Booster that is away from excessive heat,
direct sunlight or moisture, and has adequate ventilation. Airtight enclosures
are not recommended. Booster should be as close to the outside antenna as
possible in order to minimize losses from cable length to outside antenna.
3. Connect the cable from the outside antenna to the signal booster's "outside
antenna" connector. Refer to page 6 for more information on running cable.
Lightning Surge Protection is recommended for all in-building installations.
Refer to pages 3 & 6.
4. Select a location for the inside antenna. Try to choose a position in the center
of the area needing improved signal. Keep in mind that proper inside antenna
to outside antenna isolation is necessary for the system to function properly.
This may require as much as 50 to 75 feet of horizontal separation from the
outside antenna. Vertical separation also helps increase isolation. Alternate
means of isolation are possible. If physical separation is not possible, please
contact Wilson Electronics Tech Support at 866-839-9361 for suggestions on
alternate methods to achieve isolation.
5. Connect the cable from the inside antenna to the signal booster's "inside
antenna" connector. Refer to page 6 for more information on running cable.
Keep cable runs as short as possible to reduce signal loss in the system.
6. Before powering up the signal booster, verify that both the outside antenna and
the inside antenna are connected correctly, and check that all connections are
tight. Refer to page 9. Note: Be careful when plugging the connectors in so as
not to bend the center pins on the connectors.
7. Power on the signal booster by plugging in the included power supply. If the
lights are not green, please refer to pages 9-11.
Contact Wilson Electronics Customer Support Team with any questions at
Note: Kits may contain diff erent accessories
Wide Band Panel Antenna
50' RG11 Cable
(311155-1150)
For additional antenna options see pages 13 & 14.
866-294-1660 or email: tech@wilsonelectronics.com
888-503-5329
2' RG11 Cable AC/DC
Power Supply
(951127)
12V/3A (859900)
.
Lightning Surge
Protector
(859992)
2