Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
24. DO NOT USE THIS dust collector for any purpose other than its
intended use. If used for other purposes,GENERAL
disclaims any real or implied warranty and holds itself harmless for any
injury,which may result from that use.
25. IMPORTANT NOTICE: SOUND LEVEL- the sound level of this
machine during operation is rated at approximately 85 dB. Make sure
that adequate hearing protection is used and that the overall sound
level within the working environment is taken into consideration.
CALIFORNIA PROPOSITION 65
This product or its power cord may contain chemicals, including lead,
known to the State of California to cause cancer and birth defects or other
reproductive harm. Wash hands after handling.
Some dust created by power sanding, sawing, grinding, drilling, and other
construction activities contain chemicals known to cause cancer, birth
defects or other reproductive harm. Some examples of these chemicals are:
─Lead from lead-based paints
─Crystalline silica from bricks and cement and other masonry products
─Arsenic and chromium from chemically-treated lumber
Your risk from these exposures varies, depending on how often you do
this type of work. To reduce your exposure to these chemicals, work in a
well ventilated area, and work with approved safety equipment,
such as those dust masks that are specially designed to filter out
microscopic particles.
WEAR PROTECTIVE GEAR.
ELECTRICAL
WARNINGS AND CAUTIONS
1. BEFORE CONNECTING THE MACHINE to the power source, verify
that the voltage of your power supply corresponds with the voltage
specified on the motor I.D. nameplate. A power source with greater
voltage than needed can result in serious injury to the user as well
as damage to the machine. If in doubt, contact a qualified electrician
before connecting to the power source.
2. MAKE SURE YOUR FINGERS
do not contact the terminals of the power cord plug when plugging in or
unplugging the tool.
3. GROUNDED TOOLS MUST BE PLUGGED INTO AN OUTLET THAT
ITSELF IS PROPERLY INSTALLED AND GROUNDED.
Grounding provides a low-resistance path to carry electricity to ground
away from the operator, should the tool malfunction electrically.
4. DO NOT ABUSE THE CORD.
Never carry your tool by the cord or pull on the cord to unplug it. Protect
the cord from potential sources of damage: heat, oil & solvents, sharp
edges, or moving parts. Replace damaged cords immediately.
5. WHEN WORKING OUTDOORS, USE AN OUTDOOR-RATED
EXTENSION CORD.
An extension cord rated for outdoor use must be marked "W-A" or "W".
6. THIS TOOL IS FOR INDOOR USE ONLY.
Do not expose electrical power tools to moisture. Rain or wet conditions
can cause water to enter the tool and lead to electric shock.
7. FOLLOW ALL LOCALLY APPLICABLE WIRING CODES
and recommended electrical connections to prevent shock or
electrocution.
GROUNDING INSTRUCTIONS
In the event of an electrical malfunction or short circuit, grounding reduces
the risk of electric shock. The motor of this machine is wired for 120 volt
single phase operation and is equipped with a 3-conductor cord and a
3-prong grounding plug to fit a grounded type receptacle B. Do not remove
the 3rd prong (grounding pin) to make it fit into an old 2-hole wall socket
or extension cord. If an adaptor plug is used C, it must be attached to the
metal screw of the receptacle.
INTERNATIONAL
®
! WARNING !
170227
5
Publicité
Table des Matières
