Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
STARTING
8. Connect the cordset of the dust extractor to a power supply.
9. Move the On/Off switch of the dust extractor (fig 6) to the "I" position.
10. Start and operate your power tool in the normal way.
11. When the job is complete, turn off the power tool, then move the On/Off
switch of the dust extractor to the "0" position.
MAINTENANCE &
SERVICING
WARNING! Make sure the switch is in the "OFF" position and unplug
the unit from the power source before performing any maintenance.
This machine operates on 120 V; if you suspect any electrical problems
call a qualified electrician to do the verification of the electrical circuit or the
machine.
● Periodically inspect all hardware, fittings and fasteners that may have
loosened due to vibration - retighten as needed.
● Keep the motor housing clean of dust and dirt.
● Remove dust and dirt from the tool regularly with a soft cloth, brush
or compressed air. Keep the outside of the unit clean and wipe off
excessive dust or dirt with a dry rag.
● Periodically inspect inside all pipes, fittings, hoses, blast gates, and
connectors for accumulated dust build-up or other obstructions, and
clean as needed. Remove sections and vacuum or manually remove
debris as needed.
● Check and if necessary replace all damaged parts or components.
● Do not operate with a damaged canister filter - replace damaged filter
immediately.
● Periodically inspect the power cord and plug for damage. If necessary,
replace the power cord and plug at the first signs of visible damage.
● Use only recommended parts and accessories. The use of parts or
accessories NOT recommended by GENERAL
result in a risk of injury or damage to the machine.
PARTS LIST
POS.
DESCRIPTION
1
Tank
2
Clamping ring
3
Filter assy
4
Motor
5
Hex cross self-tapping screw ST5.5 x 16
6
Upper cover
7
Cross self-tapping screw M5 x 10
8
Long sponge
9
Round sponge
10
Right cover
11
Cross self-tapping screw M5 x 45
12
Cross self-tapping screw M5 x 25
13
Hex nut M5
14
Left cover
15
Cable & plug
10
INTERNATIONAL may
®
QTY.
POS.
1
16
Switch
17
Cable clamp
1
1
18
Spring washer
1
19
Lock washer
20
Seal ring
3
21
Filter bag
1
4
22
Suction hose inlet
23
Clamp for suction hose
3
24
Adaptor F
1
1
25
Suction hose
2
26
Cross screw M5 x 12
27
Hex nut M5
1
3
28
Adaptor G
1
29
Adaptor H
30
Adaptor I
1
DESCRIPTION
QTY.
1
1
6
4
2
5
1
2
1
1
4
4
1
1
1
Publicité
Table des Matières
