Technical Data; Safety; Installation - AL-KO AKS 3004 Mode D'emploi

GB

Technical data

Weight
Max. vertical coupling load
Vertical swivel range
Horizontal swivel range
Drawbar diameter
Minimum weight of trailer
Permissible overall weight
Permissible use up to

Safety

Only use AKS with class A50 trailer hitch balls
Observe the section "Possible misuse"
Stabiliser handle
Activate with one hand only
Do not use as a manoeuvring handle
Do not stand on the handle
Do not use an extension
Keep these operating instructions with the trailer
documents.
14
AKS 3004 AKS 3504
4.2 kg 4.9 kg
150 kg 350 kg
± 25° ± 25°
± 20° ± 20°
50 mm 60 mm
200 kg 200 kg
3,000 kg 3,500 kg
100 km/h 100 km/h

Installation

The procedure for exchanging the safety coupling is de-
scribed in this section.
Safety instructions
We recommend having the installation carried out
only by competent specialist workshops or our
AL-KO Service department.
Installation must be carried out in accordance with
the regulations of the EC Type Approval (Directive
94/20 EC; ECE R55)
The same clearances must be observed for all over-
run devices ( 5+6)
If the clearances are not met because of attached
parts (e.g. platform, spare wheel), use of these parts
must be tested separately
Self-locking nuts must only be used once
AKS 3004
Torx-screw
M12x78 -8.8
Caution!
The shock absorber of many overrun devices is
suspended from the fastening bolt.
This shock absorber extends automatically!
The AKS 3004 is designed for a 50 mm drawbar con-
nection. If the diameter is less than this, spacer brackets
must be provided.
Supplied spacer brackets for tube diameters:
35, 45 mm (
Replace existing bellows with supplied bellows
Insert circlip (ø 35 mm)
Translation of the original instruction manual
AL-KO safety ball coupling
Tightening torque
86 Nm
1)