Eureka NEN110 Serie Manuel D'utilisation page 8

How to maintain your vacuum cleaner
Cleaning the Filter
The filter is an effective system for removing dust.
Sponge filters require cleaning on a monthly basis (or more depending on use frequency).
Do not operate the vacuum cleaner without the sponge filter in place.
1. To remove the filter, pull on the dust cup lid clip and lift the cover upwards.
2. The filter is located inside the top cover of the dust cup.
Pull on the handle of the filter housing then remove it.
3. Tap the filter over a bin to remove the dust.
4. Take the sponge filter out of the filter housing.
5. Wash the filter under water (max. 40 degree).
DO NOT USE DETERGENTS to clean any part.
Leave it out to dry for 24 hours or until fully dry before placing it back in the vacuum cleaner.
6. Put the filter back into the housing. Put the housing and filter back into the dust cup lid. Finally,
close the dust cup lid.
7. Place the dust cup back into the vacuum cleaner until a click is heard.
8
Eureka Customer Service HELPLINE 1-800-282-2886
Filter frame handle
Filter
Cyclone separation
system