Switching The Baseplate - Bona CombiEdge Short Manuel D'utilisation

Switching the Baseplate

To switch the baseplate from short to long, proceed as follows:
1.
With a screwdriver, remove
the screws (A) that secure
the belt safety plate (B) to the
baseplate (C).
5.
Position the long baseplate
(A) and fit the belt (B) into the
pulley housing (C).
9.
Reposition the belt safety
plate (A) on the base plate (B)
and secure it with the screws
(C), starting with the center
screw.
2.
Loosen the other screws (A)
using a 5mm Allen key.
6.
Position the knob (A) in its
housing and tighten it to
increase belt tension.
Bona CombiEdge™ Short/Long Manual
®
3.
Release the belt by turning
the knob (A) manually.
7.
Check that the belt has the
correct tension.
4.
Once the knob has been
removed from its housing,
slide the baseplate to the
side (A), free the belt from the
pulley (B), and remove the
baseplate (C).
8.
Replace the screws (A) using
a 5mm Allen key.
17