EarthWise LSS10263P Manuel De L'utilisateur page 8

Fig. 5
MAINTENANCE:
CAUTION: Blades can cause injury. Do not press
the safety lock of the shear during maintenance
work.
Note: To ensure long and reliable service, regularly
carry out the following maintenance:

Check for obvious defects such as a damaged
or loose blade, housing, or components.

If the tool should stop working properly, repair
should be carried out by a qualified individual,
using identical replacement parts.
CAUTION: Never clean the trimming shears in
water (especially running water), as there is a risk
of personal injury and damage to the shears.
To obtain good cutting results, always make sure
the blades are sharp, and clean them from time to
time with a soft dry cloth.
For easier operation and longer blade life, use light
machine oil to lubricate the trimming and grass
shear blades before and after each use.
Check the condition of the cutting edges of the
blades, and always immediately remove notches
and burrs caused by stones, etc.
There are no parts inside the equipment which
require additional maintenance.
Call us first with questions about operating or maintaining this product at 1.800.313.5111
between 8:00 a.m. – 5:00 p.m. Eastern Standard Time, or send emails to earthwise@reelin.com.
GENERAL INSTRUCTIONS
Slot
Gear Pin
MAINTENANCE / CLEANING / STORAGE
CALL US FIRST !!
The Great States Corporation
American Lawn Mower Company
830 Webster Street
Shelbyville, IN 46176
www.earthwisetools.com
CLEANING / STORAGE

Clean the exterior of the tool thoroughly
using a soft brush and cloth. Do not use water,
solvents, or polishes.

Remove all debris from the tool.

After use, cover the blades with the guards
provided.

Charge the battery 3 to 5 hours before storing.

If the tool is to be stored for an extended period
of time or during winter storage, charge the
battery at least once every three months to
protect it from damage.

Store the tool in a dry secure place out of reach
of children

Do not place any other objects on top of the
tool.

This tool must not be stored in temperatures
over 104°F(40°C ) or under direct exposure to
sunlight.

Do not store the tool in places with static
electricity.
8
Fig. 6