Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
CHARGING PROCEDURE
1. Insert the charger cable into the charging inlet
on the tool.
2. Make sure the wall outlet in your home is
normal household voltage (AC120V, 60 Hz).
Insert the battery charger plug into the wall
outlet.
3. The red LED charging indicator lights up to tell
you that the battery pack is on charge. The
battery is fully charged when the red LED
charging indicator is no longer lit.
During the charging process, it is normal for
the handle of the tool to warm up.
When not using the tool for extended
periods, disconnect the battery charger from
the socket.
When the trimming shears are charging, you
must not use them.
Only charge the battery between 32°-100°F
(0°-37,8°C)
After prolonged use, allow the battery to cool
down before recharging.
ADJUST THE LENGTH OF TELESCOPIC
HANDLE
1) Loosen the handle connector (6)
2) Pull the tube out to increase the height, or push
the tube in to decrease the height.
3) Re-tighten the handle connector (6)
GENERAL INSTRUCTIONS
STARTING AND STOPPING
Starting:
1. Push the safety lock button (3) and press the
2. Release the safety lock button (3).
Stopping:
1. Release the on/off trigger switch (4).
OPERATING INSTRUCTIONS
This product is intended for light trimming of shrubs,
hedges and lawn edges. Please note that this tool is
not designed for commercial, trade, or industrial use.
Only use this product for the purpose specified in
these instructions. Any other use will void the
warranty.
GRASS CUTTER BLADE
Use the grass cutter blade for cutting the edges of
lawns and small areas of grass in private gardens
and hobby areas.
The grass cutter blade is not intended for cutting
hedges of chopping material up for composting.
Edging
Guide the tool along the edge of the lawn. For larger
lawns, it is advisable to use the telescopic handle.
Attach wheels and telescopic handle to the tool with
grass shear blade for edging mode. Guide the tool
along the edge of the lawn. The telescopic handle is
designed only for use with the grass shear blade
at the ground level After use install the blade guard.
Tips:
Do not force the unit through dense growth, and if
the blades slow down, reduce your speed.
Avoid trimming too close to dirt, sand or gravel, as
this could dull the blades and reduce the cutting
efficiency.
Do not allow the blade to contact paved surfaces,
stones or garden walls, as this will rapidly wear
down the blade.
SHRUB TRIMMING BLADE
Use the shrub trimming blade for trimming and
shaping individual bushes, shrubs, and climbing
plants in private domestic and hobby gardens.
The shrub trimming blade is not intended for cutting
grass / edging.
Cutting shrubs
6
on/off trigger switch (4) at the same time.
Before using, check the shrubs for foreign
objects e.g. wire, etc.
When using the tool hold it away from yourself
and stand in a secure position with your weight
evenly balanced on both feet.
Publicité
Table des Matières
