Atag KA2411L Notice D'utilisation page 24

24
What to do if...
Problem
The appliance does not oper-
ate.
The appliance is noisy.
Audible or visual alarm is on.
A square symbol is shown in-
stead of numbers on the
Temperature Display.
The lamp does not work.
The lamp does not work.
The compressor operates
continually.
Possible cause
The appliance is switched
off.
The mains plug is not con-
nected to the mains socket
correctly.
There is no voltage in the
mains socket.
The appliance is not sup-
ported properly.
The cabinet has been re-
cently switched on or the
temperature is still too high.
The temperature in the ap-
pliance is too high.
The door is left open.
The temperature in the ap-
pliance is too high.
Temperature sensor prob-
lem.
The lamp is in stand-by.
The lamp is defective.
Temperature is set incor-
rectly.
Many food products were
put in at the same time.
The room temperature is
too high.
Food products placed in
the appliance were too
warm.
Solution
Switch on the appliance.
Connect the mains plug to the
mains socket correctly.
Connect a different electrical
appliance to the mains socket.
Contact a qualified electrician.
Check if the appliance stands
stable.
Refer to "Door Open Alarm"or
"High Temperature Alarm".
Refer to "Door Open Alarm"or
"High Temperature Alarm".
Close the door.
Contact a qualified electrician
or contact the nearest Author-
ised Service Centre.
Contact the nearest Authorised
Service Centre (the cooling sys-
tem will continue to keep food
products cold, but temperature
adjustment will not be possi-
ble).
Close and open the door.
Contact the nearest Authorised
Service Centre.
Refer to "Operation" chapter.
Wait some hours and then
check the temperature again.
Refer to climate class chart on
the rating plate.
Allow food products to cool to
room temperature before stor-
ing.