Invicta ARATOS Mode D'emploi page 58

 Output regulator: The output regulator on the front panel is used to switch the stove from "normal output"
to "usage for long periods"
The output regulator may be used when using either logs or pellets. Instructions for use with pellets are
detailed below in SECTION 3 - INSTRUCTIONS FOR USE WITH WOOD PELLETS.
 Lighting position: When using LOGS, set the output regulator above "normal output" to increase airflow for
lighting. The regulator should not be left in this position for more than 30 minutes. Doing so may damage
the stove and its environment. Keep an eye on the stove while the output regulator is in the lighting position.
 Secondary air regulator: Using LOGS, the secondary air regulator should always remain open to achieve
complete burning. This setting needs to be adjusted only with higher than recommended airflows (see
above). This setting can be changed in this case to obtain a satisfactory output. Once adjusted, do not change
the secondary airflow setting to modify the output of the stove. Use the output regulator to increase or
decrease output.
Regulators get extremely hot. Handle only with heat-resistant glove (included).
XD, on 17/02/2020
ARATOS Plug-in
stove
dual
Page 17 sur
model P649000
41