Gpc-Bv; Gpc-Tl - Aventics GPC-BV Mode D'emploi

F G J
00129077
00129078
F G
AVENTICS | GPC | R402003957–BDL–001–AB
Make sure that any object fitted to the front plate or to the
cylinder body is absolutely flat, or flexible enough to not
deform the front plate or the cylinder body. Use shims or
washers on the screw fittings if required. Deformation may
cause the cylinder to move sluggishly or not at all.

6.3.1 GPC-BV

Equipment is generally attached to the threaded holes (F) or
through holes (G, J) in the front plate. Use screws according to the
following table:
Tabelle 9: Holes for attaching a load to GPC-BV
Piston size Ø
F
10, 12 mm M4
16 mm M4
20 mm M5
25 mm M6
32 mm M8
40, 50 mm M8
63 mm M10
80 mm M12
100 mm M12

6.3.2 GPC-TL

Equipment is generally attached to the threaded holes (F) or
through holes (G) in the front plate and in the top base plate. The
front and top have the same hole layout. Use screws according to
the following table:
Tabelle 10: Holes for attaching a load to GPC-TL
Piston size
12, 16 mm
20 mm
Ø
G
-
5.5 mm
5.5 mm
6.5 mm
6.5 mm
8.5 mm
10.5 mm
10.5 mm
12.5 mm
Ø
F G
M4 4 H7
M5 4 H7
53
Installation
Ø
J
-
4 H7
4 H7
4 H7
4 H7
4 H7
5 H7
5 H7
6 H7
Ø