Personnel Qualifications; Safety Instructions - Aventics GPC-BV Mode D'emploi

Type of risk
Consequences
Precautions
AVENTICS | GPC | R402003957–BDL–001–AB
2.3

Personnel qualifications

Assembly, disassembly, connection and commissioning require
fundamental knowledge of pneumatics, as well as knowledge of
the applicable technical terminology. For this reason, the device
may only be assembled, disassembled, connected and
commissioned by qualified pneumatics personnel or by a person
under the control and supervision of such qualified personnel.
Qualified personnel are those who can recognize possible hazards
and institute the appropriate safety measures due to their
professional training, knowledge, and experience, as well as their
understanding of the relevant conditions pertaining to the work to
be done. Qualified personnel must observe the rules relevant to
the subject area.
2.4

Safety instructions

In this document, there are safety instructions before the steps
whenever there is a danger of personal injury or damage to the
equipment. The measures described to avoid these hazards must
be followed.
Safety instructions are set out as follows:
SIGNAL WORD
Safety sign: draws attention to the risk
Signal word: identifies the degree of hazard
Type of risk: identifies the type or source of the hazard
Consequences: describes what occurs when the safety
instructions are not complied with
Precautions: states how the hazard can be avoided
37
For your safety