Storage And Transportation; Start Up Of The Equipment; Instructions For The Use Of The Power Pack And Battery Charger - Henco M-BMINI3 Manuel D'instructions

A
Caution: Th e equipment must not be operated in explosive atmospheres.
A
Caution: Complete shutdown of the equipment takes place exclusively
upon removal of the battery.
A
Caution: If oil leaks from the press tool, it must be sent to the customer
service department.
A
Caution: Th e press tool must not be operated in case of heavy rain or
underwater.
A
Caution: Hydraulic oils are dangerous for ground water. Uncontrolled loss
or disposal of hydraulic oils not in conformity with norms may be perse-
cuted under environmental protection laws.
A
Caution: It must be demonstrated that the applied components withstand
the temperatures that occur.
8.

Storage and transportation

In order to protect the battery powered press tool from possible damage it is
necessary to clean it after every usage. After operation stow away the tool in
the provided metal case and make sure it is securely closed.
9.

Start up of the equipment

Insert the battery and push until the safety switch clicks as
shown in the illustration.
For safety reasons, the battery shall only then be inserted, when
a corresponding pressing jaw is installed.
Th e press tool mustn´t be operated without a pressing jaw.
10.

Instructions for the use of the power pack and battery charger

Th e battery charger has dimensions for 230 V CA 50-60 Hz. Th e new batte-
ries are provided partially charged and must be charged before the machine
is used for the fi rst time. In order to recharge the battery charger plug must
be inserted in a wall socket and the power pack must be placed in the battery
charger. A 1.5 Ah power pack can be recharged in approximately 30 minutes.
Th e status of the charge for the power pack is indicated by the luminous diode
on the battery charger.
M-BMINI3
25