Guarantee; Guarantee/Repair - Henco M-BMINI3 Manuel D'instructions

19.

Guarantee

Every defects of the good started after the delivery must be notifi ed in writing
not later than and within 8 days after discovery of the same, encompassing
the shipment documents and a detailed description of the defect(s) involved.
In case of hidden failure, such notifi cation must also be fi led within eight days
after discovery of the same, and within one year of receiving the goods. Th e
manufacturer shall not be held liable for any defects not reported within the
started deadline. Guarantee does not cover defects or damages caused by
evident careless, misuse, wrong maintenance or repairs eff ected by non-au-
thorized centers or with non-original spares. In case of repairs the warranty is
extended on the replaced parts (not on entire tool).
20.

Guarantee/Repair

Th e customer grants a warranty of 2 years or 20.000 cycles, if the tool is ope-
rated to its appropriate use from the beginning of the warranty period.
Th e warranty period starts with the date of the 25th pressing cycle.
Th e warranty time extends to 36 month / max. 30.000 pressing cycles if a
service/maintenance is observed after 20.000 pressing cycles at an authorized
service center – ASC.
After the 30.000 pressing cycle it is recommended to service the tool every
year or after 10.000 cycles, whatever come fi rst. Th is is in order to guarantee a
proper function of the tool. A fl ashing Service LED on the tool refers the sche-
duled maintenance.
Th e unit should be cleaned after each use and dry stored. Both battery and
charger must be protected against moisture and foreign matter. Check care-
fully the functionality and intactness of the unit and the movable parts.
Th e guarantee includes the removal of all appearing damages or defects of the
unit which are due as given material and manufacturing defects at the time of
the delivery.
Th e service proof is memorized in the tool´s service history under the chapter
service diary.
Th e needed software to read out all data is in the scope of supply of the tool.
Not covered by the warranty:
• Damage/-s caused by improper use and/ or inadequate maintenance.
• Damage/-s caused by crimping/ pressing of unsuitable (not approved)
M-BMINI3
33