Menu And Specific Features - Tivoli Audio PAL+ Manuel Du Propriétaire

Menu and Specific Features:

Press and hold the Menu button on the remote to enter the main menu. Use the
remote's pq buttons and the Select button to change the items within the menu.
Use the Back button to navigate back, or wait for 15 seconds until the timeout expires.
An asterisk (*) indicates the shown menu item is currently set.
1. SCAN SETTING (FM MODE ONLY): Press the Select button and use the pq and
Select button to choose between "Strong stations only" or "All stations" when per-
forming an auto scan (see #9 (pq/Tune +/-) under "Remote Control"). Selecting "All
stations" increases the sensitivity of the scan, possibly resulting in the auto scan
stopping on noise. This feature is not accessible in Auxiliary mode.
2. TIVOLI EQ: Press the Select button and use the pq and Select buttons to adjust the
Bass and Treble. The adjusted values will be shown in "User EQ". Use the pq and
Select buttons to turn Loudness On or Off. Turning Loudness on when listening at low
volume levels is recommended since it boosts high and low frequencies resulting in a
more natural sound. Use the pq and Select buttons to activate any one of the pre-set
EQ settings. Selecting a preset EQ will over-ride any adjustment made to the Bass
and Treble settings, but Loudness will be unaffected. The "Flat" EQ restores the audio
settings to the factory defaults, meaning Bass and Treble will be re-set to zero. The
"Flat" EQ also restores Loudness Off. However, if the Bass and Treble values have been
adjusted, those settings will still be shown in "User EQ". Simply selecting "User EQ"
will reactivate the Bass and Treble settings. In the EQ menu page, the numbers to the
right hand side indicate the bass and treble settings.
3. BALANCE (FOUND UNDER TIVOLI EQ): Press the pq buttons to alter the balance.
This control only affects the Headphone Output.
4. TIME (FOUND UNDER SETTINGS):
Set 12/24 hour:
Press the Select button and use the pq and Select buttons to choose a 12 or 24 hour
clock format.
Set time/date:
Press the Select button and use the pq and Select buttons to adjust the hour and
then minutes, immediately followed by the date. You must set the Auto update to "No
update" in order to set the time manually. For more, refer to "Auto update" below.
Auto Update:
Press the Select button and use the pq and Select buttons to choose between "Update
from any", "Update from DAB" (also DMB), or "Update from FM" (RDS). For any of the
auto updates to work, you must have consistent reception of DAB or FM RDS with a
time/date signal provided. It could take up to a minute or more for the clock to update.
Tivoli Audio is not responsible for inaccurate time/date information provided by the
auto update signal.
To set the clock manually, select "No Update", and then select "Set Time/Date" under
the "Time" menu using the pq or t u buttons and the Select button to set the hour.
Repeat to set the minutes and press Select to save. Within this same "Time" menu are
additional options to set the date format and 12/24 hour clock mode.
English
13