Environmental Protection - Evolution R230 DCT Instructions

www.evolutionpowertools.com
MAINTENANCE
WARNING: Any maintenance must be carried
out with the machine switched off and
disconnected from the mains power supply.
On a regular basis check that all safety
features and guards are operating correctly.
Only use this machine if all guards/safety
features are fully operational.
All motor bearings in this machine are
lubricated for life. No further lubrication is
required.
Use a clean, slightly damp cloth to clean
the plastic parts of the machine. Do not use
solvents or similar products which could
damage the plastic or rubber parts.
Removing the blade from the machine will
allow access to the inside of the blade guard.
Any build up of debris etc can be removed
using a blunt non metallic scrapper or similar
tool (not supplied).
WARNING: Do not attempt to clean the
machine by inserting pointed objects through
openings in the machines casings etc. The
machines air vents can be cleaned using
compressed dry air. Observe all necessary
H&S precautions when using compressed air
as a cleaning medium.
Excessive sparking may indicate the presence
of dirt in the motor or worn out carbon
brushes.
If this is suspected have the machine serviced
and the brushes replaced by a qualified
technician.

ENVIRONMENTAL PROTECTION

Waste electrical products should not be
disposed of with household waste. Please
recycle where facilities exist. Check with your
Local Authority or retailer for recycling advice.
21
EN