Disposal Of The Appliance; Troubleshooting - Saeco SIN 013A Mode D'emploi

28
• If more information is required or if a
particular problem not dealt with or
insufficiently explained in these
instructions should arise, the customer
should contact his/her local dealer or the
manufacturer directly.
• We would also like to bring to the
customer 's attention that these
instructions are not part of any previous
or existing convention, agreement or
legal contract and hence have no legal
bearing.
• The obligations of the manufacturer are
based on the relative contract of sale
which includes the complete and
exclusive regulation regarding guarantee
requirements.
• The terms of the guarantee are in no way
affected by these instructions.
• The instructions contain information
protected by copyright laws.
• The instructions may not be photocopied
or translated into a foreign language
without the manufacturer 's written
permission.
13 DISPOSAL OF THE
APPLIANCE
• An appliance that is no longer in use must
be rendered unworkable.
• Remove the plug and cut the mains cable
at the base.
• Take unused appliances to a qualified
disposal centre.

DISPOSAL OF THE APPLIANCE

TROUBLESHOOTING

14 TROUBLESHOOTING
Problem Possible causes
The machine does not The machine is not properly
work connected to the power supply
The pump is too noisy There is not enough water in the tank
(para. 4.4)
The coffee is too cold The „coffee" switch light (4) was off when
the „coffee" switch (4) was pressed.
The filter holder was not in place while
heating up the machine (para. 5.1-5.2)
The milk does not froth You are using the wrong type of milk
up
The coffee flow is too There is not enough coffee in the filter
fast, and it does not holder or the coffee is not ground
make a creamy coffee finely enough
The coffee is old or unsuitable
The coffee does not flow There is not enough water in the
or only drips machine
The coffee is too finely ground
Coffee is stuck in the filter holder
There is too much coffee in the filter
holder
The "Hot water/steam" knob (6) is
open
The machine needs descaling
The upper filter is blocked
The filter in the filter holder is blocked
Coffee is leaking from The filter holder has not been fitted
the filter edges correctly into the coffee outlet socket
The top edge of the filter holder is dirty
The boiler washer is dirty or worn out
There is too much coffee in the filter
holder
If you should have a problem that is not dealt with in the above table or is not resolved by
any of these solutions please contact an authorised service centre.
29
Rimedio
Connect the machine correctly to
the power supply
Fill up the tank
Wait until the ready light comes
on
Warm up the filter holder
Check the fat content of the milk
Add coffee (para. 5.1-5.2)
Try a different blend (Ch.6)
Add water (para.4.4)
Change type of coffee
Loosen it
Scoop some of it out using the
coffee measure
Close it
Descale it (Ch.10)
Clean the filter element
Clean the filter (Ch.9)
Insert the filter holder correctly
(para.5.1-5.2)
Clean the edges of the filter holder
Clean or change the washer
Scoop some of it out using the
coffee measure