Hold Mode - Master Spas TWILIGHT Serie Manuel De L'utilisateur

SPA CONTROLS
Additional Settings

HOLD MODE

Hold Mode is used to disable the pumps during service functions like cleaning or replacing the
filter. Hold Mode will last for 1 hour unless the mode is exited manually. If spa service will require
more than an hour, it may be best to simply shut down power to the spa.
Utilities
The Utilities Menu contains the following:
A/B Temps
When this is set to On, the temperature display will alternate to display temperature from Sensor A
and Sensor B in the heater.
Fault Log
The Fault Log is a record of the last 24 faults that can be reviewed by a service tech.
Fault Log
Entry 2
Message Code M026
Back
1 Days Ago
Rest Mode
High Range
Set Temp 104°F
Sensors: A: 100 B: 96
Message:
Sensors are out of sync
DO NOT DIVE.
2:21PM
58