Master Spas TWILIGHT Serie Manuel De L'utilisateur page 51

SPA CONTROLS
The Spa Screen & Scenes
ALL EQUIPMENT ACCESS
The Spa Screen shows all available equipment to control, as well as other features, like Invert, in
one easy-to-navigate screen. The display shows icons that are related to the equipment installed on
a particular spa model, so this screen may change depending on the installation.
The navigation buttons are used to select an individual device. The device that is chosen is high-
lighted with a white outline and the text under the icon changes to white. Once a device is select-
ed, it can be controlled using the center Select Button.
Some devices, like pumps, may have more than one ON state, so the icon will change to reflect the
state that the equipment is in. Below are some examples of 2-speed Pump indicators.
Jets Off Jets Low
If the Spa has a 24 hour Circ Pump, a Circ Pump Icon will appear to indicate its activity, but out-
side of Priming Mode, the 24 hour Circ Pump cannot be controlled directly.
NOTE: The icon for the 24 hour pump that is associated with the heater will have a red glow in the
center when the heater is running.
Jets 1 Jets 2
Back
Invert
Ready in Rest Mode
Heating
SCENES
The scenes area will allow you to preset any of the devices to operate when the scene is activated.
There are four different scenes that can be preset. For example if you would like all of the pumps
to turn on at the same time: turn on the pumps, access the scenes area and highlight #1. Once
this is set anytime you highlight the #1 scene all of the pumps will activate. To store a specific
scene tap and hold the highlighted scene for 5 seconds until the display shows "scene stored" in
the bottom left corner.
DO NOT DIVE.
Jets High
Jets 3 Light
49