2- Installation Guide; Checks Prior To Installation; Necessary Tools; Installation Steps - Detnov CMD-501 Manuel D'installation Et Mode D'emploi

2- Installation guide

This section defines the steps to take to install the systems properly. The installer
must read the whole manual before starting to install the system. Not following the
instructions in this manual can damage the unit.

2.1- Checks prior to installation

Before installing this unit, make sure the following conditions are met:
• The room temperature is between –10ºC and 40ºC.
• The relative humidity is below 95%, non-condensing.
• No vibrations or blows will be caused in the area.
• The location of the station will not block access to its internal workings and the wiring
connections.
In the unlikely case that the unit is damaged on arrival, contact your distributor.
Please find below a list of basic tools for installing the station:
• Flat screwdriver for connector strips.
• Phillips PH2 screwdriver for the screws in the front housing.
• Cutting or wire-stripping pliers.
• Drill and suitable bits for fixing the station to the wall.
2.3.1- Removing the front cover.
Unscrew the 2 screws in the lower part of the front cover. Once unscrewed, remove
the cover.

2.2- Necessary tools

2.3- Installation steps

7
GB