Sony SS-X500A Mode D'emploi page 13

Securely insert the
holders into the holes
on the ventilation
openings.
Monitor cover
To use an optional
mounting bracket,
insert the holders
where the brackets are
not installed. See the
figure.
2 cm
13
( / inches)
16
To install the speaker cord holders
As shown in the figure, insert the holders into the holes on
the ventilation openings.
Evenly space the holders and insert them under the monitor
cover.
If you use an optional mounting bracket, the bracket
position and the holder positions should not overlap.
Notes
• Be careful not to short-circuit the speaker terminals
according to the wire sticking out of the insulation.
• Connect the speaker cords with correct polarity. Correct
'' connections of both speaker systems insures proper
inphase operation. If the speaker system is out-of-phase,
the bass tones seem to be missing and the position of the
sound sources become obscure.
• Do not connect the speakers to both an amplifier and a
monitor at the same time. Otherwise, the excessive electric
current may flow from the amplifier to the monitor via the
speaker cord, which may damage the monitor.
13