Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
1600A01UV3.qxp_GKS18-25 4/27/20 8:12 AM Page 14
any assembly, adjustments or changing
accessories. Such preventive safety
measures reduce the risk of starting the
tool accidentally.
Depth Adjustment
one tooth is visible below the work piece.
Excessive blade exposure below the
workpiece could result in personal injury
and/or property damage.
used to change the depth while the saw is
in operation, or for plunge cutting. If
blade adjustment shifts while cutting, it
may cause binding and kickback.
To adjust the cutting depth follow these
instructions (Fig. 4):
A.
Disconnect battery pack from tool.
B.
Depressing the depth control locking
button 22.
C.
Slide the depth control release button
21 forward.
-
For a smaller cutting depth, pull the
saw away from the foot 13;
-
for a deeper cutting depth, push the
saw toward the foot 13. The cutting
depth scale 17 has both inch and
metric scales.
Note: Not more than one tooth length of
the blade should extend below the material
to be cut, for minimum splintering (Fig. 5).
90° Cutting Angle Check
A.
Disconnect battery pack from tool.
B.
Set foot to maximum depth of cut
setting.
C.
Loosen adjustment lever 5 and the rear
bevel adjustment knob 15, set to 0° on
bevel scale 7, retighten lever 5 and knob
15 (Fig. 5).
D.
Check for 90° angle between the blade
and bottom plane of foot 13 with a
square (Fig. 6). If necessary, make
adjustments by turning the small
alignment screw 33 from bottom side of
foot 13 with a 2.5 mm allen wrench [not
included] (Fig. 6).
14
Operating Instructions
Disconnect battery pack
from tool before making
Adjust the cutting depth
so that no more than
The depth adjustment
system should be not
Fig. 4
13
17
Fig. 5
15
One tooth length should
penetrate wood for minimum
splintering
Fig. 6
33
90°
B
A
22
21
5
7
13
23
Publicité
Table des Matières
