Instructions On Cookware - CASO DESIGN Master E2 Mode D'emploi

15.2 Instructions on Cookware

caso Master E2
• Low risk of burning, since the cooking surface is only
heated by the base of the pot.
• Boiling over pot contents does not burn onto the hob.
• Rapid, fine-tuned control of the input power.
The cooking pot used for the induction cooking surface must be
made of metal, have magnetic characteristics and have a
sufficient, flat bottom surface.
Here is how to decide if the pot is suitable:
Ensure that the pot bears an inscription stating its suitability for
cooking with induction current, or perform the following magnet
test:
Place a magnet (e.g. a magnet from a magnetic board)
close to the base of your cooking pot. If it is strongly
attracted then you can use the cooking pot on the
induction hob.
The table below serves as a guide to help you choose the correct
cooking utensils:
Suitable
Cookware
Cookware with magnetic
bottom (ferreous).
Enamel-coated steel pots
with thick bases
Cast-iron pots
with enamel-coated bases
Pots made of stainless steel,
multi-layered steel, stainless
steel ferrite steel or aluminium
with special base
► Using the induction-compatible pots of some manufacturers
can lead to the occurrence of noises that are due to the design
of these pots.
Unsuitable Cookware
Pots made of copper,
aluminium, heat-resistant
glass and other non-metallic
Pots made of stainless steel
without a magnet iron core
Pots that do not sit flat on the
Pots with a base diameter of
less than 12 cm or more than
Please note
pots
hob
20 cm
54