Adjustment - CLAS PE 6000 Mode D'emploi

PE 6000 PE 6001
MOBILE SCISSOR LIFT DUAL CYLINDER LOW RAISE 3T MOVABLE ELECTRO HYDRAULIC LIFT
OIL PIPES CONNECTION:
Follow the oil pipe connection diagram.
Only qualified and authorized persons are allowed to carry out such operations. Refer to the
«oil pipe diagram»:
When connecting the hoses, pay attention to the oil pipe guard to prevent impurities from
entering the hydraulic circuit.
When connecting the oil pipes, be sure not to mistake the oil pipe reference.
During the standard installation, the control unit is close to the vehicle entry direction. If it is
positioned to the right, it is necessary to adjust its oil pipe.

ADJUSTMENT

Add hydraulic oil as instructed.
After installing the elevator as shown in image 4, having the hydraulic / electrical circuit
connected, proceed as follows:
Open the hydraulic oil tank and add 12L of hydraulic oil H46 to the tank;
the hydraulic oil is not supplied by the manufacturer.
Make sure that the hydraulic oil is free of impurities to prevent the solenoid valve
malfunction.
Activate the «MAIN SWITCH» to turn on the power
By clicking the «UP» button, check whether the engine rotates clockwise (looking down),
otherwise turn off the «MAIN SWITCH» and then change the engine phase.
When power is switched on, the high voltage in the control unit is activated. Only
authorized personnel can do this.
Oil pressure adjustment:
1) Press the «UP» button, the motor starts to bring the
platforms to the maximum possible height.
2) Open the control unit door, press the «UP» and
«SB4» buttons (as shown in picture no. 21) for a few
minutes until the air has completely escaped from
the hydraulic system.
3) Press the «DOWN» button until the platforms stop
at the minimum allowed height, press the «SECOND
DOWN» button, this way the platforms will reach
the closed position.
The oil adjustment process is completed.
4)
Picture 21 Buton SB4
43