CLAS PE 6000 Mode D'emploi page 39

PE 6000 PE 6001
MOBILE SCISSOR LIFT DUAL CYLINDER LOW RAISE 3T MOVABLE ELECTRO HYDRAULIC LIFT
RISK OF FALLING OFF - PERSONNEL
During up and down operations personnel are prohibited from entering the platforms and
the vehicle lifted to avoid falling off.
RISK OF FALLING - VEHICLE (Picture 11)
This danger may arise if the vehicle is incorrectly positioned on the platform or in the case
of vehicles of a size/or weight that does not conform to the lifting capacity. When the lift is
in use, the engine of the lifted vehicle must not be switched on. You should not place any
object on the platform and on the mobile parts of the lift but vehicles.
RISK OF SLIDE
Any lubricant contamination in the underlying area and immediately around the lift and
the platforms must be cleaned immediately. Immediately remove any oil spills. Keep the
working area clean.
RISK OF VEHICLE FALL FOR WRONG POSITIONING (Picture 12)
The center of gravity of the vehicle must be located in the lift area shown in image 12
RISK OF ELECTRIC SHOCK
The risk of electric shocks in isolated areas of electrical equipment has been canceled. Do
not use water jets, steam or paint solvents next to the lift and the control unit, and pay
special attention to keeping these substances away from the electrical control panel.
RISKS RELATED TO INAPPROPRIATE LIGHTING
The operator, installer and maintenance personnel must be able to ensure that the area
where the lift is operating is illuminated properly and uniformly in accordance with the laws
in force at the place of installation.
Picture 12
39